Your Sign
Explained
What goes into your neon sign?
What goes together to make one of our exclusive neon signs? Our guide below will give you a quick overview.
Scroll down to begin
How to hang your sign
Mark out drill holes
Mark out drill holes
Your sign will arrive with pre-drilled holes, ready to hang.
Grab a friend to hold the sign in position, then mark the holes on the wall – ensuring that you’re not drilling into wires or pipes!
Drill ‘n’ screw
Drill ‘n’ screw
Drill the marked holes and then push a plastic wall plug into each.
Screw the wall mount housings into the holes.
Attach the bolts
Attach the bolts
Take a bolt and insert it into one of the upper holes, along with a rubber washer. Add another washer to the reverse side, then screw the bolt into the housing on the wall.
Repeat until all bolts are attached.
Plug it in!
Plug it in!
Your sign is now ready to light up!
Plug the remote receiver into the clear sign lead, then the other end into the power pack.
Press go on the remote and bask in the glow!
Your remote dimmer
1Â |Â Turn on / standby
Press this button to turn on your sign or toggle standby mode. Previous lighting mode will restore.
2Â |Â Lighting mode
Switch to standard from dynamic lighting mode.
3, 8, 9Â |Â Dimmer adjust shortcuts
Switch to 100%, 50% or 25% brightness lighting modes.
4, 6Â |Â Dynamic mode adjust
Switch between dynamic modes.
5, 7Â |Â Lighting mode
Increase or decrease dynamic mode speed.
10, 11Â |Â Brightness adjust
Adjust lighting mode brightness.
Be sure to pull out the battery insulation tab on the remote before use.
Range: >15m in an open area.
Frequency: 433.92MHz
Battery type: 3V CR2025.
Hard wiring your sign
Our signs come with discreet clear cable, but you may decide to keep this hidden completely by hard wiring the sign to the mains.
Be sure to use a qualified electrician to do this and be aware that your remote dimmer will not work if the receiver is positioned inside the wall. However, the electrician will be able to connect your sign to a dimmer switch.
